User's Manual
Table Of Contents
- Microsoft Word - m_mrcsnpp_document_signature_page.doc
- Label symbolsExplanation of symbols on products and packaging. Refer to the appropriate product to s ...
- Table of contents
- Device description
- Package contents
- Device specifications
- Declaration of Conformity
- Instructions for use
- Safety and technical checks
Connecting to the USB port
To connect a printer USB cable to the programmer:
1. Correctly orient the printer USB cable plug in relation to the USB port on the programmer.
2. Insert the plug into the port.
Note: Compatible printer drivers are PCL3, PCL3e, PCL4, PCL5C (color), PCL5e, PS2, PS2 (color),
PS3. Consult your printer manufacturer to determine the correct page description language, eg, PS
(PostScript
®
) or PCL
®
(Printer Command Language).
To connect a USB flash drive to the programmer:
1. Correctly orient the USB flash drive in relation to the USB port on the programmer.
2. Insert the USB flash drive into the port.
Using the docking station
Place the docking station on a reliable surface before using. The docking station leg can be adjusted to
a desired angle.
Notes:
▪
The cradle and legs of the docking station can be separated to allow the cradle to be VESA-
mounted.
▪
Mains electricity through the power supply must be connected to the docking station in order to use
connected equipment.
▪
The USB port on the docking station should only be used to connect a USB flash drive, the USB
system connector cable, or a printer USB cable.
For instructions on using the docking station, see Table 4.
Table 4. Using the docking station
Procedure: Do this:
To dock the programmer (Figure 9): 1. With the screen of the programmer facing outwards,
place the bottom of the programmer into the cradle of
the docking station so that the docking connector
and docking pins align.
2. Press the programmer into the back of the docking
station until the docking station tab snaps over the
programmer to hold it in place.
To undock the programmer (Figure 9): 1. Lift the tab of the docking station until it releases the
programmer.
2. Lift the programmer from the docking station.
To connect the USB system connector cable to the
docking station:
1. Make sure the docking station is powered.
2. See "Connecting to and disconnecting from the
programmer" on page 23.
To connect a USB flash drive to the docking station: 1. Make sure the docking station is powered.
2. Correctly orient the USB flash drive in relation to the
USB port on the docking station.
3. Insert the USB flash drive into the port.
20 English 8880CW 2013-03
Filename Date Time
UC200xxxxxx EN
7 x 9 inches (178 mm x 229 mm)
Medtronic
Confidential
HardwareShortManual.xsl - HardwareShortTemplate.fm
Template version: 07-06-2012
M937825A001 Rev X 2013- 03