User's Manual

Table 8. Managing the programmer system (continued)
Procedure: Do this:
Email
To set up email:
Notes:
•
Email settings must be set up in order to send reports
via email.
•
Only outgoing email is supported.
•
Consult your network documentation or IT department
to determine the correct settings for your location.
1. Open the Network window.
2. Press the Email tab.
3. Press the Outgoing server input box and enter data
using the keyboard.
4. Press the Port input box and enter data using the
keypad.
5. Press the User name input box and enter data using
the keyboard.
6. Press the Password input box and enter data using
the keyboard.
7. Press the Default return email address input box
and enter data using the keyboard.
8. If desired, press the Enable SSL checkbox.
9. Press the Save button.
Locations
To add a network location path:
Note: Network locations must be set up in order to save
reports to a network location.
1. Open the Network window.
2. Press the Locations tab.
3. Press the Location input box and enter a valid
network path using the keyboard.
4. Press the Add button.
To remove a network location from the list of Existing
Locations:
1. Open the Network window.
2. Press the Locations tab.
3. Press the location row.
4. Press the Delete button.
Preferences
To change a Language setting: 1. Open the Preferences window.
2. Press the Language tab.
3. Press the radio button next to the desired language.
4. Restart the programmer.
To change the amount of time that the programmer must
be inactive before the screen saver will activate:
1. Open the Preferences window.
2. Press the Time out tab.
3. Select from the drop-down list.
To enable Patient Data Security:
Note: If Patient data security is enabled, a password
must be entered the first time patient data are requested
after the programmer is turned on. If Patient data
security is enabled, only patient data from the current
programming session can be accessed without the
password.
1. Open the Preferences window.
2. Press the Patient Data Security
tab.
3. Press the Enable Patient Data button.
4. Press the Password input box and use the keyboard
to select characters.
5. Press the Confirm Password input box and use the
keyboard to select characters that match the
Password.
6. Press the OK button.
Notes:
•
There are no rules for setting a password, such as
minimum number of characters or use of numbers.
•
If the Password and Confirm Password do not
match, a message will appear after the Next button is
pressed.
8880CW 2013-03 English 43
Filename Date Time
UC200xxxxxx EN
7 x 9 inches (178 mm x 229 mm)
Medtronic Confidential
HardwareShortManual.xsl - HardwareShortTemplate.fm
Template version: 07-06-2012
M937825A001 Rev X 2013- 03