Users Manual

161
6.2.5.9 Check the Sensor Support Mount
Confirm that the Sensor support mount remains tightly adhered to your skin
by sliding your finger along the edges of the adhesive pad and examine for any
gaps in adhesion.
Warning: If bleeding occurs at the insertion site, do not attach the Transmitter
to the Sensor. Apply steady pressure using a sterile gauze or clean cloth for up
to 3 minutes. If bleeding stops, attach the Transmitter to the Sensor. If bleeding
continues, remove the Sensor, treat the site as necessary, and insert a new
Sensor at a different site.
Warning: Check the insertion site frequently for infection or inflammation
redness, swelling or pain. Remove the Sensor and seek professional medical
help if one of these conditions occurs.
6.2.5.10 Discard the Sensor Inserter Safely
Attach the safety lock on the inserter to cover its opening and conceal the
needle inside. Follow local waste disposal regulations when discarding the
inserter. We recommend discarding the Sensor inserter into a sharps container
or a puncture-proof container with a tight lid.
6.2.6 Attach Your Transmitter
Note: If you are changing Sensor, make sure that your Transmitter was
disconnected from the old Sensor at least one minute before being connected
to the new Sensor.
Before attaching the Transmitter to the Sensor, you must have the Transmitter
battery fully charged and the PDM set up.
Snap the Transmitter into the Sensor support mount until the two flexible arms
fit into the notches on the Transmitter. The indicator light will flash green after
B ureau Veritas