User's Manual
FCC ID: XXXXXXX
Model: EP-TW3
Thank you for purchasing the EP-TW3 True Wireless Earbuds. Please read
this user manual carefully and keep it for future reference. If you need any
assistance, please contact our suppo team with your product model
number.
Package Contents
True Wireless Earbuds
Charging Case
USB-A to C Cable
User Manual
Product Diagram
- 01 -
Getting Staed
Note: Remove the protective lm from the charging case when using
for the rst time.
Charging
Fully charge the charging case before the rst use. To charge, connect the
charging case to a USB charger or charging po with the included USB-A to
C cable to charge the charging case. When the LED Charging indicator on the
outside of the charging case turns on white, the case is fully charged.
Charging takes about 2 hours, oering an additional 2 charges to the
earbuds. The earbuds should be stored in the case when not in use.
Specications
Earbuds
Model
Bluetooth Version
BT Solution
Technology
Driver (each channel)
Sensitivity
Frequency Range
Impedance
Microphone Type
Microphone Sensitivity
Microphone Frequency Range
Charging Time
Batte life time - at Standby mode
Batte Type
Operating Range
IP Rating
Weight
EP-TW3
V5.3
7006F4
HSP, HFP, A2DP, AVRCP
10mm Driver Speaker
107.9dB ±3dB (at 1kHz/0.126mV)
20Hz – 20kHz
16Ohm ±15%
MEMS (microphone chip)
-38dB
100Hz – 8kHz
About 1.5 Hours
≥60h
Polymer Batte
10m
IPX4
4g
Charging Case
DC 5.0 +/- 0.25V
About 2 Hours
Polymer Batte (320mAh)
2 times
27g
Charging Input
Charging Time
Batte Type
Number of Earbuds Recharges
Weight
- 02 -
Turn On / O
Turn On
Open the lid of the charging case or hold on the touch-sensitive
panels on both earbuds for 2 seconds when they are turned o
Return both earbuds to the charging case and close the lid or
hold on the touch-sensitive panels on both earbuds for 5
seconds when they are turned on
Turn O
Pairing
Staing with the earbuds in the case:
Open the lid of the charging case
Turn on the pairing function on the device you want to pair with the
earbuds
From the list of available devices nd and select “EP-TW3”
1.
2.
3.
Regular Use After Pairing
Once the earbuds are successfully paired with your device, they can be
switched on and o as follows:
Open the lid of the charging case, then both earbuds will turn on and
connect with your device automatically
To turn o, long press the left/right earbud touch-sensitive panel for 2s to
turn on, and it will automatically reconnect after turning on
•
•
Using the Left/Right Earbud Only
Staing with the earbuds in the case:
Take the left/right earbud out
Turn on the pairing function on the device you want to pair with the
earbud
From the list of available devices, nd and select “EP-TW3”
1.
2.
3.
Reset the earbuds
Staing with the earbuds in the case:
Open the charging case and take earbuds out of charging case
Five-Tap the touch-sensitive panel on either earbud, there will be alarm
sound "du", indicating that the record is successfully cleared.
1.
2.
- 03 -
Microphone
Touch-Sensitive Panel
Type-C Charging Input
成型尺寸：52*89mm
材质：80G双胶纸
颜色+工艺：1C+双面印制+风琴褶
Charging Case
Batte Level Indicator
Earbuds Charging
Indicator
Charging Pins
- 05 -
- 07 -
Controls & LED Indicators
Streaming Audio
Once paired, you can wirelessly stream audio on your device via the earbuds.
Music will automatically get paused when you receive an incoming phone
call and will be resumed once the call ends.
Notes
When you turn on the earbuds, they will be automatically reconnected to
the previously paired device or enter pairing mode if no paired device is
found
Either left or right earbud can be used individually once connected to
your device, if you keep the other one inside the charging case
If a single earbud exceeds the connection range for 3 minutes, the
earbud will turn o; if both earbuds exceed the connection range for 3
minutes, the earbud will turn o.
•
•
•
Play or Pause Music
Skip to Previous Track
Skip to Next Track
Answer the Call
Three-tap the touch-sensitive panel on
either earbud
End the Call
Increase Call Volume
Decrease Call Volume
Reject an Incoming
Call
Double-tap the touch-sensitive panel on
either earbud
Four-tap the touch-sensitive panel on
either earbud
When you are on a call, double-tap the
touch-sensitive panel on either earbud
When you are on a call, tap the touch
-sensitive panel on the right earbud once
When you are on a call, tap the touch
-sensitive panel on the left earbud once
Long press the touch-sensitive panel 2
seconds on either earbud
Music/Game Mode
Activate Siri or other
Voice Assistants
Double-Tap the touch-sensitive panel on
either earbud
Long Press the touch-sensitive panel 2
seconds on the left earbud
Long Press the touch-sensitive panel 2
seconds on the right earbud
Taking Calls
Increase Music Mode
Volume
Decrease Music Mode
Volume
When you are on music mode, tap the touch
-sensitive panel on the right earbud once
When you are on music mode, tap the touch
-sensitive panel on the left earbud once
FCC warning:
Any Changes or modications not expressly approved by the pay
responsible for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to pa 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful inteerence, and
(2) this device must accept any inteerence received, including
inteerence that may cause undesired operation.
These limits are designed to provide reasonable protection against
harmful inteerence in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful inteerence to radio communications. However, there is no
guarantee that inteerence will not occur in a paicular installation.
If this equipment does cause harmful inteerence to radio or television
reception, which can be determined by turning the equipment o
and on, the user is encouraged to t to correct the inteerence by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
ThedevicehasbeenevaluatedtomeetgeneralRFexposurerequirement.
Thedevicecanbeusedinpoable exposureconditionwithoutrestriction.
- 10 -
4.Select EP-TW3
3.Turn on BT on your device
- 06 -
EP-TW3
PAIRING
1.Open the lid of the charging case,both earbuds will then turn on
and enter pairing mode
WEAING INSTRUCTIONS
2.Take out the left/right earphones (the L/R mark on the inside of the
earphones), snap the earphones into the outer auricle, and rotate the
earphones according to the direction of the arrow to make the
earphones wear more stably.
Note: Remove the protective lm from the charging
case when using for the rst time.
CHARGE THE EARBUDS AND CHARGING CASE BEFORE
USE
- 04 -
Tear o
Tear o
Batte Life
Music playback 7h and call 5h
(50% volume)
- 08 - - 09 -
Return Left earbud to the
charging case
Return Right earbud to the
charging case
The Indicator White Light Flashes
The Indicator White Light Solid Light
Earbuds Charging Indicator Status
LED Batte Level Indicator Status
The Right White Light ashes 3 times
The Left White Light ashes 3 times
The Light Flashes White Quickly
<20% batte remaining
Charging case charging
Charging case fully charged
FAQ
The earbuds are on, but not connecting to my device
For the earbuds and your device to establish a connection, you need to put
them both in pairing mode. Please follow the instructions in the “Pairing”
section of this manual.
I’ve connected the earbuds with my smaphone but can’t hear any
sound
Double-check the volume level on your smaphone and the earbuds. Some
smaphones require you to set up the earbuds as an audio output device
before the audio can be transmitted. If you’re using a music player or other
device, please make sure it suppos the A2DP prole.
The sound isn’t ve clear or the caller can’t hear my voice clearly
Adjust the volume on your smaphone and the earbuds. T moving closer
to your smaphone to rule out the possibility of inteerence or wireless
range-related issues.
The maximum range is 10m. However, the actual range depends on
environmental factors. For optimal peormance, keep your device
connected within a range of roughly 4m to 8m and make sure that there are
no major obstacles (like reinforced steel walls) between the earbuds and
your device.
The earbuds won’t turn on
T charging the earbuds for a while. If the earbuds still won’t power on,
please contact our suppo team at the email address given in Warranty &
Product Care & Use
Keep away from liquids and extreme heat
Don’t use the earbuds at high volume for extended periods, as this may
cause permanent hearing damage or loss
•
•
Customer Suppo.
I put the earbuds back in the charging case, but the earbuds are still
connected
The charging case is probably out of power. T charging it.
CE Statement
Max RF power level:
BT classic (2402–2480MHz): 4dBm
RF exposure assessment has been peormed to prove that this unit will not
generate the harmful EM emission above the reference level as specied in
EC Council Recommendation (1999/519/EC).
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Excessive sound pressure from earphones and headphones can cause
hearing loss.
Notice: This device may be used in each member state of the EU.
User Manual
True Wireless Earbuds
FCC ID: 2ABMR-EP-TW3