User Manual

TROUBLESHOOTING
Factory Reset (clear paired devices)
A factory reset will clear all paired devices from the memory of the X7. To
perform a factory reset, first put the headset in pairing mode as described in
the Pairing with Bluetooth devices section. Once in pairing mode, press and
hold all three remote buttons simultaneously for approximately 5 seconds.
The red LED indicator light will flash 5 times once the memory has been
cleared, and the unit will automatically enter pairing mode to be paired with
a new device.
Hard Reset
To perform a hard reset, insert the charging cable and at the same time press
and hold the Multifunction button until the earphone powers on. Unplug the
charging cable and plug it back in to complete the reset.
Visit MEEaudio.com for additional Bluetooth information and troubleshooting.
LED INDICATOR LIGHTS
The status indicator light of the X7 is located on the remote.
Headphone Status Indicator Light
Charging Solid red status indicator light
Fully charged Solid blue status indicator light
Pairing mode
Status indicator light flashes red and
blue in an alternating manner
Powered on but not connected
Status indicator light flashes blue once
every 10 seconds
Powered on and connected to
Bluetooth device
Status indicator light flashes blue twice
every 5 seconds
Incoming call
Status indicator light flashes blue
continuously
10