STEREO BLUETOOTH® WIRELESS HEADPHONES model: AF32 USER MANUAL part of the series
PACKAGE CONTENTS Runaway AF32 Stereo Bluetooth Wireless Headphones Charging cable (USB – 3.5mm) Stereo audio cable (3.5mm – 3.
PRODUCT OVERVIEW Stereo Bluetooth Wireless Headphones RIGHT EAR CUP A B C D E F G H LED indicator light Multifunction button ( / ) Previous track button ( ) Next track button ( ) Volume down button ( ) Volume up button ( ) Headphone / charging jack Microphone + - 2
CHARGING *** You must completely charge the headphone before the first use *** Connect the USB charging cable to any powered USB port and to the 3.5mm jack on the right earcup. Make sure it is plugged in fully. Charge time is typically 2-3 hours. The red LED light will stay lit while the headphones are charging and will blink or turn off completely when the headphones are ready for use.
TURNING ON AND OFF To turn on, press and hold the Multifunction button for approximately 3 seconds. The headphones will say “Power on” and the blue LED light will flash. To turn off, press and hold the Multifunction button for approximately 4 seconds. The headphones will say “Power off” and the red LED light will flash. PAIRING WITH BLUETOOTH DEVICES *** Your headphones must be paired to a Bluetooth device before it can be used. It is only necessary to pair your headphones once with each device.
LOCATING THE BLUETOOTH MENU iPhone, iPad, and iPod Touch a) On your device, go to Settings b) Select Bluetooth. If Bluetooth is not on, turn it on. The iPhone/iPad/iPod will automatically search for new devices Android™ Phones and Tablets a) On your device, go to the Settings menu b) Select Bluetooth (on older Android devices Bluetooth is found in the Wireless & Networks menu). If Bluetooth is not on, turn it on.
CONTROLS The Runaway can control media and phone calls from a smartphone or tablet. 1. ADJUSTING THE VOLUME FUNCTION OPERATION Increase volume Press the Volume Up button Decrease volume Press the Volume Down button NOTES When the volume reaches the minimum or maximum level the Runaway will produce a short tone. Note: Volume can be adjusted only while media is playing or during a phone call.
CONTROLS (CONTINUED) 2.
CONTROLS (CONTINUED) 4. ADDITIONAL FUNCTIONALITY FUNCTIONALITY OPERATION NOTES Redial last call* Double press the Multifunction button when no call is in progress Headphones will say “Last number redial” Activate Siri ®/ voice command/ voice dialing* Press and hold the Multifunction button for 2 seconds Headphones will produce a tone and media will be paused. Press and hold Multifunction button for 2 seconds again to cancel.
MULTIPOINT Multipoint allows two Bluetooth devices to be connected to the Runaway simultaneously, providing additional flexibility for your multimedia experience. 1. MULTIPOINT PAIRING To use two Bluetooth devices with the Runaway, first pair them by following the pairing procedure described in the Pairing with Bluetooth Devices section on Page 4 for each device and then turn off the headphone. Both devices will need to be paired before multipoint can be used.
MULTIPOINT (CONTINUED) 2. MULTIPOINT FUNCTIONALITY STATUS FUNCTION OPERATION Media playing on one device Play media on other device Pause audio playback on the active device and start audio playback on the other connected device.
USE AS WIRED HEADPHONE The Runaway can be used as a wired headphone by plugging one end of the included stereo audio cable into the 3.5mm jack on the Runaway and the other end into any audio device with a standard 3.5mm headphone jack. Plugging the audio cable into the headphone will disable Bluetooth functionality until the cable is unplugged. Note: the built-in microphone of the Runaway will not work when the headphones are used in wired mode.
SPECIFICATIONS Bluetooth Version 4.0 Bluetooth Profiles Supported A2DP, HSP, HFP, AVRCP Driver 40 mm dynamic driver Frequency Response 20Hz to 20kHz Operating Range 10 m (30 ft) Music Playback Time 15 hrs Talk Time 15 hrs Standby Time 150 hrs TROUBLESHOOTING Visit www.meelec.com/bluetooth for additional Bluetooth information and troubleshooting. WARRANTY The Runaway is covered by a 1 year manufacturer warranty. For more information, visit www.meelec.com/warranty.
NOTES MEElectronics and its logo are registered trademarks of S2E, Inc. All rights reserved. iPhone®, iPad®, iPod touch®, Siri® is a registered trademark of Apple Inc. Android™ is a registered trademark of Google Inc. Windows® Phone is a registered trademark of Microsoft Corporation in the United States and other countries. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by MEElectronics is under license.
www.meelec.