User manual

11
USE AS WIRED HEADPHONE
The Runaway can be used as a wired headphone by plugging one end of
the included stereo audio cable into the 3.5mm jack on the Runaway and the
other end into any audio device with a standard 3.5mm headphone jack.
Plugging the audio cable into the headphone will disable Bluetooth
functionality until the cable is unplugged.
Note: the built-in microphone of the Runaway will not work when the
headphones are used in wired mode.
SAFETY AND CARE
• When not in use, power the headphones off and store in a cool, dry place.
Battery performance will be severely decreased when stored in extreme
temperatures: below -10°C/14°F or above 45°C/113°F including direct
sunlight.
• Clean with a soft cloth, damp with diluted soap water solution if necessary.
Never use chemical cleaners.
• There are no user replaceable/reparable parts in the headphone.
Disassembling it will void your warranty.
• Do not expose the headphones to liquids. If the device comes in contact
with liquids, quickly wipe away. If submersed in water, do not turn the
device on until completely dried. Note: liquid submersion voids the
warranty.
• Do not use around flammable gasses as fire or explosion may occur
• Replacement parts and accessories are available online at
www.meelec.com
WARNING:
Using headphones at high to moderate volumes for extended periods of
time will result in permanent hearing damage. It is advised you keep volume
levels moderate to low at all times for your safety. Do not use while driving a
car, cycling, operating machinery, or performing other activities that require
hearing surrounding sounds.
It is advised to turn the volume on your device all the way down before
connecting your headphones, then gradually increase the volume until you
reach a comfortable listening level.