User manual

7
Rigging the fixture
Caution!
1. The installations must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures if you have doubts concerning the safety do not install.
3. Unit is to be 24inches away from flammable materials (decoration material)
4. Use high quality installation equipment to hang unit.
When rigging a unit it is very important that you follow common safety procedures. Rigging requires extensive experi-
ence including but not limited to calculating working loads, material being used and periodic safety inspections. If you
lack these qualifications, do not attempt the installation yourself, instead use a professional structural rigger.
When rigging the unit always be secured with a secondary safety attachment. The installation location of the projector
has got to be built in the way that it can hold 10 times the weight for 1 hour with out any harming. Installation should be
checked at least one time a year by a skilled person.
Main Control
The control board on the fixture base is your interface to access and
control all the functions on the unit. Its LED display gives you a code
view of the options and functions. The following will explain each func-
tion and its options.
Introduction
Press the ▲ and then press the Enter button to Access the setup menu
Setup Menu
001
Resetting
MENU UP DOWN ENTER
▲ ▼
DMX
ERR
Set
Manu Sys
Advan
DMX Will operate using a DMX controller
Sound The light will activate it’s built in programs with sound activation
Random The preprograms will be activated randomly
F-Sleep 8 Slow large figure 8 movement program
F-Stand 8 Slow small figure 8 movement program
Draw Up 8 Figure 8 movement in the up position
Auto 1 thru 4 Built in programs
Run Mode
►Setting
Run Mode
DMX Address
Channel Mode
Invert Pan
Invert Tilt
Swap Pan-Tilt
Encoder Pan-Tilt
No DMX Signal
Display Power Save
Load Default
DMX
001
15CH
OFF
OFF
OFF
ON
KEEP
OFF
Press Enter use the ▲ or ▼ to select the desired DMX start Channel. Press Enter to confirm the setting .
DMX Address
Run Mode
DMX Address
Channel Mode
Invert Pan
Invert Tilt
Swap Pan-Tilt
Encoder Pan-Tilt
No DMX Signal
Display Power Save
Load Default
DMX
001
15CH
OFF
OFF
OFF
ON
KEEP
OFF
►