User manual

Chapter 3: Web Interface
Enter iCAMView Subnet Mask. The value is normally 255.255.255.0
Gateway
This item is to set iCAMView Gateway.
To learn more about the above, see Appendix C: IP address, Subnet and
Gateway
Obtain an IP address
This allows the user to choose either to set iCAMView LAN IP address; manually
OR using DHCP (default).
Note:
Click Apply to confirm. iCAMView will reboot. You MUST now manually enter the
NEW IP address in your Browser in order to open the Web Interface.
ii. DNS Server IP
Fig.20 iCAMView DNS Server IP
Primary DNS Server IP
This item sets iCAMView primary DNS Server IP address. By default this is set
to 168.95.1.1
Secondary DNS Server IP
Use this to set iCAMView Secondary DNS Server IP address. iCAMView will
use the Secondary DNS Server IP address if the Primary DNS Server IP
address is not working. The default IP is 168.95.192.1
iii. LAN Port Number
Fig.21 iCAMView LAN Port Settings
Web access Port Number
This determines the LAN port from which the webpage (using HTTP protocol) is
accessible thru your Router. By default the LAN port number is 80.
If this port is changed, say to 82, then http://xxx.xxx.xxx.xxx:82 (where
xxx.xxx.xxx.xxx is iCAMView LAN IP address as shown on the LCD) must be
used in order to access iCAMView web interface in LAN.
Video access Port Number
This determines the LAN port from which the video image (using UDP protocol)
is streamed thru your Router. By default the LAN port number is 9001.
iCAMView - user manual -21-