User manual

Chapter 3: Web Interface

Fig.23 iCAMView PPPoE setting

When Connection should be made

Disabled : Default setting.

Connect always : iCAMView will automatically dial up and maintain

continuous connection.

Automatically reconnect

Enter the interval between each reconnection and number of automatic

reconnections. The reconnection interval can be set between 30 to 9999

seconds.

Enter the login name assigned by your ISP.

Enter the password assigned by your ISP.

3.2.3.5 Wireless Setting

This option determines iCAMView Wireless Network Settings. This option is only

configurable if a compatible wireless USB dongle is attached. To set this up, you’ll

first need to use the LAN IP (as shown on the LCD) to access iCAMView.

Note:

Once the wireless configuration is setup, the wireless IP address will be shown on the LCD

instead of the LAN IP. To check the LAN IP thru the LCD, unplug the wireless USB dongle.

i. IP Address

Refer to section 3.2.3.4 (i) above. This will be the wireless LAN IP. It will be

different from the LAN IP.

ii. DNS Server IP

Refer to section 3.2.3.4 (ii) above. This will be the wireless DNS server IP. It

can be different from that of the LAN IP.

iii. Wireless

Connect a compatible Wireless USB dongle to enable this feature.

iCAMView - user manual -26-