User manual

Chapter 3: Web Interface
Max FPS
This allows the Administrator to limit the bandwidth allocated to each account.
The Administrator can set a figure of 3 to Unlimited FPS (“frames per second”).
Viewing Hours
When the Permission level is set to either Operator or Viewer, the Administrator
can set the time to which the camera can be viewed.
Fig.27 iCAMView Permit Hours Configuration
Click Configure to bring up the Camera Viewing Hour window. The
Administrator can set up to 4 different Permit Hours (in 24hr format). Click
Apply to save. Click Close to exit without saving.
Note:
The Reset button will revert the fields to initial values prior to any changes being
made. It does not undo changes once Apply has been clicked.
ii. Block IP address
Fig.28 Blocking LAN IP address
Blocked IP List
This allows the Administrator to block specific LAN IP address from accessing
iCAMView. Manually enter the IP address in dotted decimal notation and click
Add Block IP. The blocked LAN IP address will be listed at the bottom.
Click Delete to remove it from the list.
iCAMView - user manual -29-