Specifications

OCTE SAFEdoc
TRANS
Battery Charging
1. Wear PERSONAL PROTECTIVE EQUIPMENT INCLUDING SAFETY GLASSES when
working around batteries. REMEMBER, BATTERIES POSE POTENTIAL DANGERS
RELATING TO CORROSION, CHEMICAL BURNS, AND EXPLOSION.
2. Use fender covers to protect vehicles’ painted surfaces.
3. Make certain the battery is filled with distilled water if it is a maintenance style of battery.
4. During cold weather make certain the battery is not frozen.
5. AVOID SPARKS AND FLAME SOURCES around the battery and cable areas.
6. Keep workspace clear of debris and obstructions.
7. Disconnect battery charger from alternating current source (wall outlet) before battery
clamps are connected or disconnected. Remove negative cable from battery if battery is in
the car.
8. Before hooking-up charger, turn charger off. Make positive battery clamp connection first
and the negative connection last.
9. Charge batteries only in a well-ventilated area. Set controls to the correct voltage,
recommended time, and the correct charging rate. DO NOT OVERCHARGE THE
BATTERY!
10. When removing charger, turn charger off first. Remove negative battery clamp connection
first, and the positive connection last.
11. Always make the teacher aware you are going to use the charger.
AT ALL TIMES – IF IN DOUBT, SEE YOUR INSTRUCTOR
Transportation SAFEdoc Page 18