Specifications

OCTE SAFEdoc
TRANS
Power Tools (2)
11. If the tool is equipped with a three-prong plug, it should be plugged into a three-
hold electrical receptacle. Never remove the third prong.
12. Never use power tools in damp or wet locations or if the worker is perspiring.
Moisture helps electricity flows more easily through the body.
13. Rubber gloves and footwear are recommended when working outdoors in damp
conditions.
14. Never carry a tool by its cord, or pull the cord to disconnect it from a receptacle.
Never carry a plug-in tool with your finger on the switch.
15. Unplug tools before replacing any broken, dull or damaged bits or blades.
16. Be careful not to overreach. Keep your balance and proper footing when working
with power tools..
17. When you have completed an operation with a power tool, switch it off and lay the
tool down in a safe manner after it stops. Keep the rotating blade or bit away from
your legs and body.
18. Keep floor around work area clean.
19. Be sure the power switch for a portable tool is “off” before plugging it in.
AT ALL TIMES – IF IN DOUBT, SEE YOUR INSTRUCTOR
Transportation SAFEdoc Page 37