Setup guide

Mega 200VWR Router
Chapter 4: Configuration
128
Special Dial Codes
The following table lists the special dial codes that are built into the router:
Option Description
Flash-hook
Switch to PSTN line
Note: This is a quick press of the hook switch. On most phones, a
button is provided which provides Flash-hook functionality. The
button is marked "FLASH","RECALL" or sometimes “R”
*69
Return the last missed call (for SIP service only)
Note: Entering this on a phone will call the last number that dialed
the phone. For example A makes a call to B, but hangs up before
B answers. If B enters *69, A will be called back .
## Last dialed number redial function
*20
Turn the Do Not Disturb mode on
This mode enables a “Do Not Disturb” feature on a phone, such
that any phone which calls it will receive an engaged tone and the
called phone will not ring. For example, B enters *20 and hangs
up. A makes a call to B, but receives the engaged tone. Phone B
does not ring.
*80 Set the Do Not Disturb mode off
*74<x><number>#
Set the number for Speed dial code ‘x’, where ‘x’ is a number
between 2 and 9.
Note: <x> is a number between 2 and 9, and <number> is the
number to dial. To dial a speed dial number from a phone
connected to the VoIP Router , dial :
<x>#, where <x> is a number between 2 and 9.
These settings will affect your setting on the Speed Dial page of
the WEB GUI.
*90<phone-number>
This is how to make a Blind Call Transfer. With this function, the
specified <phone-number> is the number that you wish to transfer
the call to. This function is for a SIP service only.
Note: You use Blind Call Transfer when you have a call in
progress (incoming or outgoing) and decide you wish to transfer
the call to another phone. To transfer the call, perform the following
steps:
1. Hook-flash to get a dial tone.
2. Dial *90<phone-number> (e.g. *907401).
A
fter hearing the
confirmation tone, you can hang up. The transferred call will hear a
ringback tone, and the third-party phone (the one that the call has
been forwarded to)_will be rung. When the third-party phone is
picked up, the transferred call will be connected.
If the third-party phone does not answer, the caller being
transferred must hang up to cancel the connect attempt.