Setup guide

Mega 200VWR Router

Appendix A: Product Support and Contact Information

160

c) Confirm that the corresponding LAN LED is lit. If it is not lit, you may have

plugged the cable into the wrong port on the back panel of your PC.

d) You can connect up to 4 network devices directly to the Mega 200VWR.

4. Connect the ADSL micro filters

a) If you also intend to use traditional telephones (for normal voice calls) on the

ADSL line, you need to connect the included ADSL micro filters. (These units

filter out any data noise on your voice lines.) Note that this setup is not for

VoIP calls, but traditional analog voice calls on your ADSL line. These

calls are charged separately.

b) Plug the micro filter into the remaining Telkom ADSL wall-socket. (G).

c) Plug the telephone into the micro filter using the included (grey) telephone

cable. (H)

d) Important Note: Make sure that you do not

connect any micro-filters between

the Telkom wall socket used for the router and the router itself. Refer to the

route indicated by (C) and (D) below.