User's Manual

megascan M1 User Manual Rev. 1.0 Updated on 28th August, 2009
Technical Contacts and Enquiry: [e-mail] Website: www.scanmega.com
(This user manual / product specification is subjected to be changed without prior notice) P. 11
2.3 Start up Procedures
1. Before installation of megascan M1, please follow the steps below:
2. Install and fasten the megascan M1 in right location.
3. Before turn ON the megascan M1 by connecting ethernet cable to PoE
Router/switch.
4. The default IP / subnet mask is as follows: 192.168.1.254 / 255.255.255.0, change
the IP setting for your network.
5. Please make sure the antenna port is connected an UHF antenna before turn on
the RF power for testing.
Caution: Each port must have either an antenna or a terminator connected.
Do not apply power to the megascan M1 unless an antenna or terminator is
installed on each antenna port.
2.4 Caution
Danger of Electric Shock
• Disconnect the device from the electric supply before cleaning or performing
maintenance on the machine.
• Keep this device dry.
• For in-door use only. Not designed for out-door purpose.
• Turn off or unplug the machine when it is not in use.
Please read the information contained within this user manual prior to attempting
installation and operation of the RFID Reader. Failure to install and operate the RFID
Terminal (megascan M1) in accordance with the information contained in this manual may
result in unsatisfactory performance.