Use and Care Manual

- 15 -
5.TROUBLESHOOTING
FAULT INDICATIONS
CAUSES AND RECTIFICATIONS OF FAULTS
The following table assists in localizing and rectifying minor errors.
The appliance emits a beep after being switched on and in the event of an error.
The beep will not stop until the fault has been rectified or the appliance has been
switched off.
This appliance is equipped with an overheating protection mode. If the
temperature of the cooktop exceeds 500ºF, the error message “E05” will appear.
For safety reasons, the appliance shuts off automatically in order to avoid damage.
In case of an “E05” error message, please unplug the unit and wait for 3 minutes
in order to reset the appliance. Once the device has been reset, it can be plugged
back in and turned back on.
If the error message continues to be displayed after an extended period of
time or after resetting the appliance, it must be sent to customer service to
be examined.
Only qualified electricians, who have been trained by the manufacturer, may
carry out any repairs on electrical equipment.
Only customer service departments authorized by the manufacturer may carry
out repairs during the warranty period, otherwise the warranty will be null and void in
the event of any subsequent damages.
Improperly performed repairs can cause considerable dangers for the user
and damages to the appliance.
Defective components must always be replaced with original replacement parts.
Defective components must always be replaced with original replacement parts.
Only such parts will guarantee that the safety requirements are fulfilled
!
!
!
!
1. Read all instructions before using.
2. This appliance generates heat. Do not touch the hot surface of the
ceramic cooktop.
3. To protect against electrocution do not immerse any part of the
appliance in liquid.
4. Unplug the appliance when not in use and before cleaning. Allow
appliance to cool down before cleaning.
5. Inspect the appliance, its power cord and plug for any damage before
using. If there appears to be any damage or if the appliance shows
signs of malfunctioning, do not use the appliance. The appliance should be
returned.
6. Do not use outdoors.
7. Do not allow cord to touch hot surfaces or hang over sharp edges
such as those on countertops.
9. Do not place the appliance on or near a hot gas or electric burner, or
heated oven.
10. Always connect power cable to the appliance first, then insert the plug
into the electrical outlet. Before unplugging, make sure the appliance is
not in use, then unplug.
11. Do not use this appliance for any unintended use.
12.
12. Do not leave the appliance unattended during operation, so that you
can intervene quickly in the event of danger.
13. Do not move the appliance during operation or with hot cookware on the
hot plate.
14. Ensure that the cookware is properly centered on the cooktop. It must not be
positioned on the control panel or on the frame.
15. In order to prevent overheating do not place any aluminum foil or metal
15. In order to prevent overheating do not place any aluminum foil or metal
panels on the appliance surface.
17. Although the induction cooktop itself does not produce any heat during
the cooking process, the temperature of the cookware does heat up the
cooktop.
18. Keep the cooktop and the underside of the pot clean and dry at all times.
18. Keep the cooktop and the underside of the pot clean and dry at all times.
If liquid gets between the base of the pot and the cooktop, this liquid can
vaporize and the resulting pressure can cause the pot to jump into the air,
with a resulting risk of injury.
19. SAVE THESE INSTRUCTIONS.
- 4 -
IMPORTANT SAFEGUARDS