Setup Notice

Setup
2. Connect dongle to PC
Screw-in the extended range antenna to the USB dongle and
connect the dongle to your PC to any USB port.
1. Download and install deca hub
Requirements:
- Steam VR
- Windows 10
Download and Install the DecaHub installer from this link:
https://www.deca.net/decamove/setup
Open the DecaHub software from your Windows Start menu
DecaHub software will show the connection status change from
?Closed? to ?Open?.
It is recommended to connect the dongle to a front USB port if available.
3. Pairing
Turn on the DecaMove by pressing the button for 2 seconds.
DecaMove LED will change from orange (not connected) to blue
when it successfully connects to dongle.
Setup
Notice the connection status changes to ?Streaming? and the
compass icon rotates according to how you rotate your DecaMove.
Pairing should happen automatically once the dongle is connected and
theDecaMove is switched on. Please refer to the troubleshooting section
for any issue.
4. Calibration
(For first time use only)
DecaMove delivers precise, low latency, and high accuracy hip
tracking. The device? sensor fusion relies heavily on the
magnetometer which MUST be calibrated before first use.
Calibration is easy and should take less than 20 seconds, please
forllow the instructions in this link:
https://www.deca.net/decamove/support/decamove-magnetometer
-calibration-procedure/