Operation Manual

Operating the receiver
10
Operating the receiver
Switching receiver ON/OFF
You can switch on the receiver by pressing OK, s t or by using one of the numeric buttons
1…0. The last activated channel will be displayed (e.g. 0015).
The digital receiver is switched into standby mode by pressing .
ATTENTION: Only by pulling the power cable the receiver is disconnected from the power
supply completely.
TV & Radio mode
You can choose between the operation mode TV (viewing TV channels) and RADIO (listening
to radio channels) by pressing RADIO.
Volume control & Muting
The volume level can be adjusted by pressing ◄ ► or VOL -/+ . The corresponding scale is
displayed on the screen.
Hint:
- It is not possible to change the volume level while the menu is active.
- The volume control only affects the audio output at the TV, VCR and AUDIO
ANALOG OUT ports of the receiver.
By pressing the button you can totally switch off the audio output (muting). For switching on
again, simply use the same button.
Selecting a channel
1. Using the directional up/down keys
To change the channels stepwise press the buttons s / t. In order to switch the
channels quicker hold these buttons pressed longer.
2. Using the numeric keys (direct input)
One or more digit channel numbers can be input by using the numeric buttons 0…9
and pressing OK. Not available channel numbers are ignored.
3. Using the channel list
By pressing the LIST button the last activated channel list or favourite list is
displayed. Browse the channel list by pressing ◄ / ► or s / t and activate the
desired channel by pressing OK.