Operation Manual

Installation

Installation – Antenna configuration

1) Antenna:

Contains all available satellites. By using ◄ or ► you can select the satellite your LNB is

directed to. After pressing OK you can rename the selected satellite name.

2) Antenna power

Here you can switch on/off the supply voltage for the LNB (◄ or ►).

3) LOW Band

The oscillator frequency for LOW band can be fine adjusted by pressing ◄ or ►.

For directly entering the frequency press OK and use the numeric buttons 1-0 then.

4) HIGH Band

The oscillator frequency for HIGH band can be fine adjusted by pressing ◄ or ►.

For directly entering the frequency press OK and use the numeric buttons 1-0 then.

5) DiSEqC switch

If your receiver is connected to a satellite antenna system that receives several satellites

(multi feed antenna system) via a DiSEqC controlled switch unit:

Specify the input of the DiSEqC switch, where the selected LNB (line 1) is connected to

(◄/►).

6) Toneburst switch

If your receiver is connected to a satellite antenna system that receives two satellites (multi

feed antenna system): Specify the input of the A/B-Switch where the selected LNB (line 1)

is connected to (◄ or ►).

7) DiSEqC mode

Choose the required DiSEqC mode by pressing ◄ or ►.

For fixed antennas select DiSEqC 1.0, for motorized antennas DiSEqC 1.2 is required.

Press EXIT to leave the menu. If you want to store the modifications choose Yes by pressing

◄ or ►. For the previous settings you have to choose No. You confirm the new settings by

pressing the OK button.

Attention:

If you have selected DiSEqC mode “DiSEqc 1.2” than the menu item Motor settings appears in

the previous menu Installation. There you will find all necessary parameters for setting up your

motorized antenna system (see page 23).