Operation Manual

Installation

Channel search

1.Press st for moving the cursor to line satellite. There select the satellite you want to

scan (◄ or ►).

2.Move the cursor to line search mode (st). There use ◄/ ► for selecting the desired

search mode.

Transponder:In this mode a certain transponder (channel) is scanned only. Therefore

you have to specify this transponder by entering its frequency,

polarisation and symbol rate.

Satellites: In this mode all stored transponders of the selected satellite are scanned

for new channels.

3.In line Encrypted you can specify whether you want to search for encrypted channels,

too.

No = encrypted channels are ignored

Yes = encrypted channels are searched, too

The following settings are used only in search mode Transponder.

4. Frequency:

For entering the frequency of the desired transponder please select line Frequency. Then

press OK and use the numeric input buttons 1…0 for entering the 5 digit frequency.

Confirm your inputs by OK.

5. Polarisation:

In menu item Polarisation you can set the polarisation (vertical or horizontal) of the

desired transponder by using ◄ or ►.

6. Symbol rate:

For entering the symbol rate of the desired transponder please select line Symbol rate.

Then press OK and use the numeric input buttons 1…0 for entering the 5 digit symbol

rate. Confirm your inputs by OK.

For starting the Channel search please navigate to line Start scan (keys CH st) and press

the OK button on your remote control.

Now a new menu is displayed with two lists displaying the founded TV and RADIO channels.

Thereby the „Status:“ graphic keeps you informed on the progression of the channel search:

- Status scan => search algorithm is active

- Status end => search algorithm is finished

You can leave this menu by pressing EXIT. If not finished, the channel search algorithm is

aborted. If new channels are found, you are asked to store them (Yes). Select your choice by

◄/► and confirm with OK. If selected YES the new channels are stored at the end of the

channel list now.

Chapter Channel List (page 25) describes how to sort the channel list.

Installation – Factory reset

This menu item allows you to reset the receiver to its default factory status. Afterwards the

receiver starts up with the Welcome Screen (initial installation) again.