User manual

First installationFirst installation
ENGLISH ENGLISH
08
09
Please install before starting the device all cable connections to the satellite dish and to the TV set.
(Only for changes)
By the first time using of the Receiver the First
Time Installation appears on the screen. This
menu includes two options:
• General Setting
• My Dish
In the menu General Setting you can find the settings for language and others. You can change between the
two option by the navigation buttons UP and DOWN. If one of both has a dark blue background, than the
option is active. Start the option by pressing the OK button. The single settings can be change by pressing the
navigation buttons RIGHT and LEFT. The menu you can cancel or quit by the EXIT button.
OSD Language
Here you can set the OSD language. Change the lan-
guage by using the navigation buttons RIGHT and LEFT.
The new language will be set automatically.
Audio Language
With this option you can define the first language which is provide by DVB-S broadcast. By setting the OSD
language the Audio language will be set also automatically.
Subtitle Language
Here you can define, if you want to display Subtitles and in which language they appears on the screen.
Auto Time Zone
Here you can set the Time Zone setting automatically. The information will be taken from the EPG information.
You can set also the Time Zone manually. Here for choose the setting OFF and than the next option is active.
Time Zone
Press the navigation buttons LEFT or RIGHT until your time (depending on Greenwich Meridian) appears on
the screen. Plus values are in east direction and minus values in west direction. Before you continue the next
steps, you shall be sure about the satellite installation system. Depend of the different way to install the dish
and orientation, different kind of options are available.
Bevor Sie bei den Einstellungen beginnen, sollten Sie
sich über das installierten Satellitensystem im klaren
sein. Es gibt hier eine Reihe von unterschiedlichen
Optionen.
If you orientates the dish to a specific satellite and
you use a single or Multi-LNB. Each LNB is directly
connected with the cable to the receiver, than you
uses these settings.
Switch off the two options Switch Type and Tone-
burst.
• Switch Type None
• Toneburst Off
Navigate to the third option until the is highlighted
with dark blue. Start this option by pressing the OK
button. The list is empty. Now you can add a satellite.
Press the RED button to add a satellite. A list of pre-
sets satellites appears on the screen. Choose the
satellite which is orientated by the dish and confirm
the selection by pressing the OK button.
1. Single connection between Satellite / LNB
and Receiver
Hinweis:
Die Untertitel werden nicht auf allen TV Sender und zu allen Sendungen ausgestrahlt. So kann es vorkommen,
dass bei aktiver Anzeige trotzdem keine Untertitel vorhanden sind.
Settings
My Dish