User manual

ENGLISH ENGLISH
14
15
First installation First installation
In combination of DiSEqC 1.0/1.1 and Toneburst you can use instead of between 4 satellite has a total of 8 dif-
ferent satellites. Select all the satellites. With the DOWN navigation key you can control the second page of the
satellites.
DiSEqC 1.2 provides additional control of three plants by DiSEqC commands, via a single coaxial cable. Of the
motor‘s staff was also a record producer (rod USALS) defined which is to find the satellite position is particularly
simple. With the appropriate receiver is sufficient to enter the geographical position and the satellites are found
automatically - provided that the curved path of the rotary engine has been correctly set mechanically.
Select the option LNB DiSEqC switch setting 1.2/USALS.
After all settings are running you can start searching.
Here you have the option of the two selected satelli-
tes scan individually or both of them together.
You now have two ways to make the settings, either
via a DiSEqC 1.2 or USALS.
DiSEqC 1.2
Choose from the satellites, you can achieve with your
motorized satellite dish.
USALS
Define the search parameters by the options Set Limit, Set Area and Set LNB
Set Limit
Definition of angle of rotation in west and east direction
Set Area
Define the area where the dish are placed
Set LNB
Choose the parameters of the LNB
4. Using more than two satellite by DiSEqC 1.0/1.1 with Toneburst 5. Using more than two satellite by DiSEqC 1.2 / USALS
BLUE:
Single Satellite Search
RED:
Both Satellite Search in one run
GREEN:
Delete all Satellite
YELLOW:
Delete the selected Satellite
Press the RED or BLUE button and you can influence the search and found the TV to where you are either with
Scan Mode, a standard search or perform a „blind“ search.
Now, all search parameters are set and the scan can run. Press the OK button and the scan begins.
All received TV and radio stations are displayed in the two lists. After the scan, the TV and radio stations are
stored in the two lists and the unit goes into the live image of the first TV station.
Press the BLUE button and you can influence the
search and found the TV to where you are either with
scanning Mod. (Scan Mode) a standard search or per-
form a „blind“ search.
Now, all search parameters are set and the scan can
run. Press the OK button and the scan begins.
All received TV and radio stations are displayed in the
two lists. After the scan, the TV and radio stations are
stored in the two lists and the unit goes into the live
image of the first TV station.