User`s manual

5 First Time Installation

After all connections have been made properly, switch on TV and

make sure the receiver is connected to the Main Power. Press

Power button to switch receiver on. If you are using the receiver

for the first time or restored to Factory Default, the Main Menu will

appear on your TV screen.

(1) Select [OSD Language] and press / key to

select the desired language.

(2) Select [Satellite Setup] and press / /OK to

Satellite Setup menu.

(3) Select the desired satellites by using the /-Keys

and press OK to confirm.

Press/key to switch to the satellite settings and use the /-keys to select.

Use the/key to change the settings.

Note:

If you are using more than one Satellite you need to assign the satellites the correct

DiSEqC-LNB that is used in your satellite installation.

(4) Press the BLUE button to proceed.

(5) Select how to search and which channels should be stored.

Select the Scan Mode. Normally Standard is the best choice.

Select the channels to be stored. For this device only free available channels can be stored.

Select if all or only TV or Radio channels should be stored.

(6) Press the BLUE button to start the scan process.

(7) Once channel tuning is complete, you are now ready to watch TV.

5.1 Program Manage Settings

To access the Menu, press the

MENU button and select [Program].The Menu provides options to adjust

the Program Manage Settings. Select an option and press OK or  to adjust that setting. Press the EXIT

button to exit the Menu.