User`s manual

11
EN
5.2.4 Video output
Depending on your TV set you can change the Video output
signal for SCART connections.
[CVBS]: CVBS output.
[RGB]: RGB output.
5.3 Channel Search
To access the menu, press MENU and select
[Search Channel]. The Menu provides options to adjust the
Search Channel settings. Select an option and press / to
adjust the settings. Press EXIT to exit the Menu.
5.3.1 Satellite
Configure the settings of satellites.
Satellites' list: Press / to select a satellite, whose settings will be shown at right side.
LNB Type: Press //OK to show the list of LNB Types which is shown as frequencies of local oscillator.
You also can enter frequency by User Single, User Dual at bottom of the list.
LNB Power: Press /to set the LNB power.
22K: Press /to switch on or off the 22K,which is set with auto when LNB Type is dual local oscillator.
Toneburst: Enable or Disable the toneburst switcher.
DiSEqC1.0: select the right port up to 4 for the right LNB.
DiSEqC1.1: select the right port up to 16 for the right LNB.
Motor: Press LEFT/RIGHT to select DiSEq
C1.2 or DiSEqC1.3. Then Press OK to
show the menu to set position.
DiSEqC1.2: Move the motor to a right position to lock the signal.
DiSEqC1.3: Move the motor according to the local and satellite positions.
Motor Settings: (Select DiSEqC and press OK to open)
Move Auto: Press LEFT/RIGHT to start to
move West/East. It will be stopped automatically
when the signal is locked.
Move Continue: Press LEFT/RIG
HT to start to move West/East. It will keep moving until you
stop it.
Move Step[1]: Press LEFT/RIGHT to move just a step.
Store Position: store current position of motor.
Goto Position: Press LEFT/RIGHT to goto the position stored.
Goto Reference: Rest all the positions.
Goto X: goto the position calculated from the local and satellite positions.