User Manual

In the event that these conditions cannot be met, then the FCC authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID of the module
cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization. In such cases, please involve a FCC certification specialist in order to
determine if a Permissive Class II Change or new Certification is required.
Upgrade Firmware:
The software provided for firmware upgrade will not be capable to affect any RF parameters as
certified for he FCC for this module, in order to prevent compliance issues.
End product labeling:
This transmitter module is authorized only for use in device where the antenna may be installed
such that 20 cm may be maintained between the antenna and users. The final end product must
be labeled in a visible area with the following: “Contains 2APJ4-SLM550”
Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user's manual of the end product which integrates this
module. The end user manual shall include all required regulatory information/warning as show in
this manual.
When the module is installed inside another device, the user manual of the host must contain
below warning statements:
1. This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired
Any company of the host device which installs this modular with unlimited modular approval should
perform the test of radiated & conducted emission and spurious emission, etc. according to FCC
CFR Title 47 Part 15 Subpart C Section 1R Title 47 Part 15 Subpart E Section15.407: 2016 and
FCC CFR Title 47 Part 2/ FCC CFR Title 47 Part22/ FCC CFR Title 47 Part24/ FCC CFR Title 47
Part27/ FCC CFR Title 47 Part90 and FCC Part 15B requirement, only if the tests result comply
with standards requirement, then the host can be sole legally.
Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Please notice that if the ISED certification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is installed must also
display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains IC:23860-SLM550” any similar wording that expresses the same meaning
may be used.
l'appareil hôte doit porter une étiquette donnant le numéro de certification du module d'Industrie
Canada, précédé des mots " Contient un module d'émission ", du mot IC:23860-SLM550 ou
d'une formulation similaire exprimant le même sens, comme suit
MeiG_SLM550_Hardware Design Manual
MeiG Smart Technology Co., Ltd 6/89