ITEM NO.
Thank you for purchasing this product. Please read this manual carefully before use and retain it for future reference. Technical parameter of the helicopter Fuselage Length:610MM Gross Weight: about 392g Overall height: 245MM Main Rotor Diameter: 475MM Motor: #180 Battery: Li-polymer 7.4V Gear Ratio: 14:1 Charging Time: about 2 hours Introduction 1.Coaxial-rotor design, built-in gyro and negative rotation of rotors are used to increase the helicopter’s stability and operability.
Product/spare parts included in this packaging Description Qty(pc) Description Qty(pc) Helicopter 1 Adaptor 1 Manual 1 Remote controller 1 Major parts power socket Charging plug Helicopter split charging device Camera/ Photograph switch all-in-one charging device Charge the helicopter To meet the different demands from different customers worldwide, two different charging devices have been designed for charging.
How to charge the helicopter by all-in-one charging device. Turn off the helicopter. Unplug the battery cable from the helicopter, then, insert the plug of the battery cable into the port of the charger (matching the plug to the port) to start charging. Once charging is proceeding, red light is on. When charging is finished, the red light will turn into green light. Full charge takes about 2 hours. Preparation for flight 1.
Hints 1.If the helicopter keeps self-rotating in the air even there is no control signal given, you could correct it by adjusting the trimmer of gyro on the remote control. 2.If the helicopter keeps flying forward/backward in the air even there is no control signal given, you could correct it by adjusting the trimmer on the remote control.
Video function and videography device If installed the C4002 videography device(should be ordered separately from MJX), the helicopter has the videography function. TF memory card card reader videography module Videography device How to install the videography device Insert the TF memory card into the videography module.(Pic9) Fix the videography module onto the bottom of the helicopter by screws.
3. After shooting is finished, take out the TF memory card from the videography module and insert it into the card reader, then, insert the card reader into the USB interface of the computer to watch the video. TIPS To stop shooting, please press the shooting switch on the remote controller. Directly unplug the battery cable or take out the TF memory card from the videography module will result in loss of the video data.