User Manual

12
Chapter 3
Functional Details
External components
The RedLab 1024LS has the following external components, as shown in Figure 3.
 USB connector
 LED
 Screw terminal banks (2)
Figure 3. RedLab 1024LS external components
USB connector
The USB connector is on the right side of the RedLab 1024LS housing. This connector provides +5 V power
and communication. The voltage supplied through the USB connector is system-dependent, and may be less
than +5 V. No external power supply is required.
LED
The LED on the front of the housing indicates the communication status of the RedLab 1024LS. It uses up to 5
mA of current and cannot be disabled. The table below explains the function of the RedLab 1024LS LED.
LED Illumination
LED Illumination Indication
Steady green The RedLab 1024LS is connected to a computer or external USB hub.
Blinks continuously Data is being transferred.
Blinks three times Initial communication is established between the RedLab 1024LS and the computer.
USB
Connector / cable
Screw terminal
Pins 21 to 40
Screw terminal
Pins 1 to 20
LED