® ON AIR™ CONTROL 2.
THANK YOU FOR CHOOSING JBL For more than 60 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We’re confident that the JBL system you have chosen will provide every note of enjoyment that you expected – and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL.
CONNECTIONS 1 MUTE 0 INPUT 3 VOL 2 ID CODE A R INPUT L C D B 4 5 – ID CODE 12 3 4 12 3 4 + NOTES: For the sake of simplicity, we have used the terms “receiver” and “A/V receiver” when describing the connections and operation, throughout the manual. We feel that the majority of customers purchasing this system will connect it to a receiver of some type.
CONNECTIONS Step 3 Connect the speaker wire (included) to the push terminals on the Active Speaker 5 and the push terminals on the rear of the Passive Speaker. See figure 4 . ID CODE 12 3 4 – + – + TO RIGHT SPEAKER TO LEFT SPEAKER DC 20V SUB OUT LINE IN RIGHT CHANNEL SPEAKER LEFT CHANNEL SPEAKER Step 4 Plug the Transmitter Module and Active Speaker into the wall outlet. Make sure the transmitter’s antenna A is extended upwards.
Subwoofer Output The JBL OnAir Control 2.4G wireless speaker system includes a subwoofer output 7 on the rear of the Active Speaker. This output allows you to feed the low-frequency sounds to a separate powered subwoofer. A powered ubwoofer will deliver deeper bass response than is possible with the speakers alone.
OPERATION Adjusting the Volume Wall Mounting the Speakers When using the JBL OnAir Control 2.4G wireless speaker system, turn the volume level on your receiver to approximately half-way. If using with a portable audio device, turn its volume control to the maximum output. From this point on, you will use the remote control included with the JBL OnAir Control 2.4G wireless speaker system to adjust the volume.
mounted on drywall, the use of properly selected and installed wall-anchors and screws is essential. Make sure that the screw head is at least 0.36 inches (approximately 3/8 inches) or larger in diameter so that it can properly hold the backup cord eyelet ⁄. g. Holding the speaker cabinet ¶ with both hands, reinsert the ball portion of the ball/shaft £ into the wall bracket ¢. h. Hand tighten the molded nut ™ while positioning the speaker for the intended orientation. i.
Declaration of Conformity We, Harman Consumer Group International 2, route de Tours 72500 Château du Loir France declare in own responsibility that the products described in this owner’s manual are in compliance with technical standards: EN 61000-6-3:2001 EN 61000-6-1:2001 Laurent Rault Harman Consumer Group International Château du Loir, France 9/06 JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.