Technical information

Configuration: Main Menu
After entering the right password, the main menu page shows up. This page
contains an overview of the most important configuration and status parameters for
the system.
The start page gives a short overview of the most important configuration parameters
and the runtime statistics of the unit. In the upper left corner you can read which
LANTIME model and which version of the LANTIME software you are using. This
LANTIME software version is a head version number describing the base system and
important subsystems. Below the version you will find the actual hostname and
domain of your LANTIME unit, the IPv4 and IPv6 network address of the first
network interface and on the right side the serial number, the uptime of the system
(time since last boot) and the notification status.
In the second section the actual status of the GPS reference clock and the NTP
subsystem is shown, additional information about the GPS receiver are also found
here. This includes the number of satellites in view and the number of good satellites
in view.
The third section shows the last messages of the system, with a timestamp added. The
newest messages are on top of the list. This is the content of the file /
var/log/messages, which is created after every start of the system (and is lost after a
power off or reboot).
By using the buttons in the lower part of the screen, you can reach a number of
configuration pages, which are described below.
47