Operating Instructions and Installation Instructions

4 - Grill

4.1 - Open the oven door and remove all internal accessories.

4.2 - Remove the burner / reflector unit by

loosing the screw fixing the reflector and

remove all elements from the injector support

by turning downwards

4.3 - Unscrew and remove the injectors and replace them those corresponding to the available gas see table 1

4.4 - Screw the burner / reflector and put in place the internal accessories.

5 - Regulating the primary air - only the oven burner and / or grill

5.1 - move the air regulator which is input to the burner near the inyector to increase or decrease the air passage.

6 - Low flow adjustment:

6.1 - Light the burner on and put the knob to the Low Position.

6.2 - In this position, remove the knob of the tap.

6.3 - With screw - driver perform on the taps

screw until the flame is conveniently regulated

to the low position and stable

6.4 - Reassemble the knob and pass quickly from the Full On Position to the Low Position, several times, to ensure

that the flame remains stable.

7 - After connecting the unit, check for gas leaks with soap and water solution. NEVER USE A FLAME.

8 - Place, near the inlet gas connection, a label indicating the type of gas for which the appliance is now prepared.

"Appliance prepared for..."

INSTRUCTIONS MANUAL