Operating Instructions and Installation Instructions

INSTRUCTIONS MANUAL
20
3.10 ELECTRONIC PROGRAMMER
SETTING UP THE ACTUAL HOUR:
Once the electrical connection is made to the oven, the display blinks and
shows 0.00.
Press keys (1) and (2) at the same time, then press keys (-) and (+) to set up
the actual hour within 4 seconds; the oven remains in manual operation and
no programming is necessary.
GENERAL REMARKS:
- Between 10.00 p.m and 6.00 a.m. the display intensity dims automatically.
- If not deactivated as per the following instructions, the acoustic signal is cut off after 2 minutes.
- Any programming described hereunder is activated after approx. 4 seconds from its setting up.
- 23 hours and 59 minutes is the maximum time allowed for programming the oven.
- If the supply voltage fails, all the programmed settings are erased. When the supply voltage returns, the display
blinks and shows 0.00. Set up the actual hour and the programme again to reset the equipment operation.
SAFETY LOCK FOR CHILDREN
The programmer is provided with a safety lock which stops the cooking programming and consequently the oven
operation;
Lock running:
- press both switches (1) (2) at same time for about 8 seconds
- the display shows "ON"; release the switches
- press switch (+); the display shows "OF" and the symbol "..key.."
Now the safety lock starts running and after about 5 seconds the display shows the current time and the symbol
"..key.."
Lock deactivation:
- press both switches (1) (2) at same time for about 8 seconds
- the display shows "OF"; release the switches
- press switch (+); the display shows "ON"
Now the safety lock is deactivated and after about 5 seconds the display shows the current time.
Automatic Operation
The oven can be programmed to switch on and of f automatically.
To do this proceed as follows:
1. Select the required cooking function and temperature using the function selector and the thermostat dial.
2. Press key (2) and set the cooking time by pressing keys (-) and (+) within the next 4 seconds
3. Press key (3) and set the end of the cooking time in the same way.
The actual time reappears and pilot light (AUTO) remains ON, when the cooking process starts, pilot light (A) will
remain on. The cooking time left can be controlled by pressing key (2), or the time can be changed by repeating
the same procedure.
Reset the cooking time to 0.00 to erase the preset programme, and when the actual time reappears, press key (4)
to reset the manual function. Once the cooking process is over the acoustic signal goes off and the oven is
automatically switched of f. Press one of the keys from (1) to (4) to return the programmer to the manual function.