Operating Instructions and Installation Instructions

9880022302-EN-250717.doc

Built-in measurements

The dimensions of the opening to be made on the cabinet for fitting the oven are

indicated in the figures. Ensure that the cabinet where the oven is to be installed is able

to support the weight of 30 kg for FI-A36 – FI-45 – FI-60 – FI-NB60 – FI-FTO60 –FI-

65; 45 kg. for FI-90 , FI-88 and FI-70; 70 kg for FI-TWIN. For the opening in the

cabinet follow the respective dimensions of the type of oven purchased, indicated in

fig.01 for FI-60 – FI-NB60 – FI-FTO60, fig.02 for FI-65 fig. 03 for FI-70, fig.04 for FI-

88 fig.05 for FI-90 fig.06 for FI-TWIN fig.07 for FI-A36 and fig.8 for FI-45.

It is necessary to create an opening in the rear part of the bottom of the cabinet or in the

oven support shelf, to allow sufficient air to circulate for the cooling of the oven during

functioning.

Ensure the oven is safely installed inside the cabinet. Use screws A for fixing of the

oven.

■ ELECTRIC CONNECTION OF THE OVEN ■

Make sure that the electric current has been removed before connecting the oven to

the electric mains.

Attention: During the electrical connection ensure the flexible cable is not damaged. If

it is not intact, to avoid any risk, it must be completely replaced with a cable having the

same characteristics and only by qualified and skilled staff.

The oven requires single-phase alternate current 220-230-240 V~ 50-60 Hz, using

flexible cable. Ensure the household power supply can support the electric load of the

device. (see serial plate). The electric safety of this appliance is only assured if the same

is correctly connected to a system having efficient earth connection, according to the

legal standards in force.

In case of permanent connection to the electric mains, apply a bipolar switch dimensioned to the

corresponding charge, with an opening for every contact of at least 3 mm.

In models where present, the flexible cable is supplied without plug. The plug to be used

must be suitable for the electric load of the product and must comply with the current

regulations.

The installer must ascertain that the section of the socket cables is suitable to the power

absorbed by the oven, as indicated in the serial plate.

The connection socket must be easily accessible. Disconnection of the appliance from

the electrical supply must be permitted after installation is performed.