Operating Instructions and Installation Instructions

9880022302-EN-250717.doc
16
EN
N
■ MAINTENANCE AND CLEANING ■
Disconnect the electric power supply before performing any type of maintenance
on the product
Do not use steam cleaners on the appliance.
Do not use rough, abrasive materials or sharp metal scrapers to clean the oven door, as
they can scratch or damage the surfaces and cause the glass to break. Do not use acid
products (like anti-scaling agents) as they can damage the enamelled parts.
Turn off the heating elements, wait for the internal parts of the oven to cool down before
touching or cleaning them. Pay great attention to the cooking grills. Clean the oven with
care. Be careful to avoid steam burns if a sponge, or damp cloth, used for cleaning
residue, comes into contact with a hot surface. Moreover, some detergents create
noxious fumes on contact with the heat.
Regular maintenance
Periodically check the state of the rubber gasket located around the oven opening. This
guarantees correct functioning of the oven. If gasket damage is noted, contact the nearest
technical after-sales centre.
Cleaning the surfaces
The enamelled or stainless steel parts must be treated with caution. Use water or specific
products, drying thoroughly with a soft cloth. Do not use abrasive products. In case of
tough deposits on enamelled parts, use a plastic sponge or similar, soaked in hot water
and vinegar. If food residues or oil, sugar, grease stains, etc., are not immediately
removed after use of the oven, they can become more difficult to remove. It will make
removing them easier if the internal parts of the oven are cleaned while they are still
warm.
Due to an increasing presence of new products on the market, it is impossible to
establish a list of items useful for cleaning this appliance. Read the manufacturer
instructions carefully to verify the possible use of the detergent.
Warning: screen printed symbols
The symbols stamped on the appliance (e.g. around the knobs) can be damaged if dirt
(food, oils, liquids, salts etc.) remain for an excessively long period on them. Dirt
residue must be removed immediately but use products specifically for steel as other
overly abrasive ones could cause the symbols to fade.
OPERATING ANOMALIES
In case of abnormal operation immediately contact the nearest qualified and
authorised technical service centre.