Operation Manual

INSTRUCTIONS MANUAL
13
3.3 THE ELECTRIC PLATES USE
ATTENTION
The electric plate is covered by varnish for protection.
Before the first use, the plate must function empty, with the knob placed in position 6 during 3 minutes.
3.2 HOW TO USE BURNERS OF THE COOKING TOP
If you use the burners properly, the consequence will be a maximum ef ficiency, thus saving energy.
The power of the burners is shown on table 1.
In order to obtain this, you must choose pans according to the size of the burner see the table 2.
If the flame is wider than the pan you are wasting energy.
YES NO
Attention:
Use containers that do not exceed the edges of the desk
IGNITION OF THE HOT PLATE BURNERS
To ignite the burners proceed as follows:
- Bring the flame near the burner
- Selecting the burner to use, push the corresponding knob and turn it counter clockwise to the "full position",
indicated by a large flame.
- To reduce the power to turn the knob to the "low position", indicated by a small flame.
To switch off the burner, just turn the knob clockwise to the "of f position", indicated by a black circle in the upper
position of the panel.
IMPORTANT:
In the models with triple burner be attention with this point:
Put in the correct position the cover spreader of the middle screw down the cover spreader, to guarantee a
good burning.
HOT PLATE BURNERS WITH SECURITY
Some models have a security system in the burners of the cooking top (models with refª V).
If the gas supply is deficient or if the flame is extinguished accidentally, the gas circuit will be automatically closed.
To restart is necessary an user intervention.
In this case and after verify that isn't a gas supply problem, wait at least one minute and repeat the lighting.
For ignite this type of burner it's necessary maintaining the knob under pressure for 10 seconds.
After this time release the knob of the burner which must be in function.