Operating Instructions and Installation Instructions
4 INSTRUCTIONS FOR MAINTENANCE AND CLEANING
Warning: Servicing should be carried out only by authorised personnel.
Before maintenance or cleaning your cooker, switch off the circuit breaker, turn off the isolating
gas valve or the gas mains and allow the cooker to cool down.
GENERAL CLEANING
Adequate maintenance and cleaning will prolong the life of the appliance, as well as ensure trouble-free service.
Before you let down the cover glass it is necessary to decrease the temperature of the burners and electric plate.
The cooker must be washed with warm water, using a damp sponge and ordinary detergent.
Never use scouring powder, steel wool or acids to clean the cooker.
The stainless steel parts should be washed, after the use, with water and dried with a soft cloth. If the spots still
persist, it is necessary to use a non-abrasive detergent or warm vinegar.
The glass of the oven's door should be washed with warm water and a nylon pad soaked in ordinary detergent.
Avoid scrubbing the front panel, because this will erase the designs stencilled over each knob.
The enamelled grids of the knob can be washed in the dishwasher.
The cooker not must be cleaned with vapour equipments (eg. steam cleaners).
After a possible grid removal for cleaning, we recommend to verify the presence of such rubber pads and to put
the grids back in their stable and centred correct position
BURNERS CLEANING
The burners should be cleaned with soapy warm water and well rinsed and dried.
Ensure there are completely dry before using.
CLEANING CERAN COOKTOP
After use, once the cooker has cooled down, clean thoroughly as even small amounts of dirt can become impossible
to remove when re-heated.
Do not use abrasive pads, sponges or powders to clean, as these products can scratch the surface of the glass.
Small amounts of dirt can be removed using a damp cloth or hot, soapy water.
Soap stains should be removed with water, and the glass should then thoroughly dried.
For encrusted dirt, it is recommended that you use a glass scraper, with a
metal blade, which can easily be found on the market.
Only clean when the surfaces is cold.
INSTRUCTIONS MANUAL
24