Operation Manual

INSTRUCTIONS MANUAL
5
2.2 GAS CONNECTION
The cooker is provided with a label placed on the rear panel near the gas inlet, showing the type of gas
and pressure for which the appliance has been originally adjusted.
Before connecting this appliance check if is prepared for the type of gas and pressure available in your
home. If not, it is necessary to convert the appliance to another gas as indicated in section 2.4.
This appliance is suitable for connection to Natural and Propane Gas. Refer to gas pressure shown on the
data plate and in the table nº 1.
All possible type of gas and pressures are shown on the data plate, and in the table nº 1.
The butane gas bottle are unable to function in places with low temperatures. In this case is recommendable
to substitute the Butane for Propane gas (operation to be done by one qualified installer). Never place a
propane gas bottle inside the building.
You may connect the appliance to a gas bottle fitted with its respective regulator, or to a gas network tap.
Since this is a movable unit, the following types of tubes could be used:
- Flexible rubber or elastomer tube, certified according an applicable standard fixed to an adequate inlet
gas connection and held tight by a clamp on both ends
- Flexible stainless steel tube, certified according an applicable standard, with threaded connections.
- Flexible rubber or elastomer tube, certified according an applicable standard, with threaded connections.
ATTENTION:
- Ensure the tube is not bent or twisted.
- Ensure the tube is not in contact with the rear panel.
- The tube must be replaced before expire date.
- The tube must be checkcable in is whole length.
- The clamps should be adequate for a good tight
- The maximum length of the flexible rubber tube must be 1500 mm.
The connection to the cooker should be done on the same side of the point of feeding, in way that the
tube doesn't cross the backs of appliance. If necessary change the gas inlet or request to the services of
technical attendance the adaptation tube so that the entrance of gas in the appliance is done on the side
correct.
After connecting the unit, check eventual leaks with a frothy product. NEVER USE A FLAME.