User guide

MEITRACK MT90 User Guide
Copyright © 2014 Meitrack Group All rights reserved. - 7 -
will blink for 10s.
8
Micro USB
port/Mini USB port
Used for charging, connecting a computer for parameter settings, and upgrading
software.
9
Volume+/GPS Log
button
 Press the button to turn up the volume.
 Press and hold down the button for 2s to start hands-free conversation.
 In standby mode, press and hold down the button for 2s, when the buzzer
sounds “BI” once, the recorder will run automatically. (The MT90 will record
the route every 30s automatically when a GPS signal can be received. Route
records can be exported by using a computer.
 Press and hold down the button for 2s again, when the buzzer sounds “BI”
twice, and the recorder will stop automatically.
Note: To avoid misoperations, you can disable the GPS Log button by using Meitrack
Manager (default: valid).
10
Volume-/GPRS
button
 Press the button to turn down the volume.
 In standby mode, press and hold down the button for 2s, when the buzzer
sounds “BI” once, the GPRS function will be enabled automatically.
(Precondition: GPRS parameters are set, and the default GPRS message
interval is 10 minutes.)
 Press and hold down the button for 2s again, when the buzzer sounds “BI”
twice, the GPRS function will be disabled automatically.
Note: To avoid misoperations, you can disable the GPRS button by using Meitrack
Manager (default: invalid).
11
Lanyard hole
Place the lanyard through the hole.
12
Battery cover
After removing the battery cover, install the battery and SIM card.
5.2 Indicator
To start the MT90, press and hold down the power button for 3 to 5 seconds. The blue and green indicators blink on for 1s and
blink off for 1s simultaneously.
GPS Indicator (Blue)
Status
Description
Steady on
The MT90 is charging.
Blink every 5s
The MT90 is in sleep mode.
1s on and 1s off
The GPS is invalid or the MT90 is initializing.
Off
The GPS is valid.
GSM Indicator (Green)
Status
Description
Steady on
A call is coming in or busy.
Blink every 5s
The MT90 is in sleep mode.
1s on and 1s off
No signal is received, or the MT90 is initializing.
Off
The MT90 is connected to the GSM network.