User's Guide

Table Of Contents

MEITRACK P88L GPS Personal Tracker User Guide

4. Install water resistant rubber stoppers.

Take water resistant rubber stoppers out of the

packing box, and install them properly.

5. Charge the battery by magnetic USB cable.

To charge the battery, connect the device to the wall

charger or a computer through the magnetic USB

cable. When you use the device for the first time,

you are advised to turn off the device and then

charge the battery for one hour.

Note: Do not remove the battery unless necessary

during charging. While charging, the device may

heat up. This phenomenon is normal and does not

affect the device’s lifespan or performance. If the

battery power is low, it may affect positioning and

data transmission. So you need to charge the

battery before using.

After the Nano SIM card and battery are installed properly and the battery is charged, users can

turn on the device and start to use it for the first time.

Please read the following instructions to know more about its functions.

4 Device Configuration

This chapter describes how to use Meitrack Manager to configure device parameters. For details

about Meitrack Manager, see the MEITRACK Manager User Guide.

4.1 Configuring Device Parameters on Your PC

Before using Meitrack Manager, install the USB driver and Meitrack Manager. (If the operating

system of the PC is Windows 10, maybe the USB driver already exists.)

Connect the device to the PC by using the USB cable.

Right-click My Computer, select Manage, and view Device Manager. If SIMicroelectronics