User's Guide
Table Of Contents
- 1. Safety Instructions
- 3. Using Your Digital Audio Baby Monitor
- 4. Disposal of the Device (environment)
- 6. Troubleshooting
- Power/Link Indicator on the parent unit does not come on
- Power/link indicator on the parent unit flashes and ‘Not Linked’ displayed on the screen.
- Indicator on the parent unit screen flashes
- The parent unit beeps
- Cannot hear sound or baby cry from the parent unit
- The Digital Audio Baby Monitor system produces a high- pitched noise
- Battery pack in the parent unit is running low quickly
- 7. General Information
Troubleshooting
17
Cannot hear sound or baby cry from the parent unit
•
The volume level in the parent unit may be set too low. Increase
the volume level of the parent unit. Refer to section 3.3 For volume
level settings.
•
The parent unit and the baby unit may be out of range with each
other. Reduce the distance between the units, but not closer than 1
metre.
The Digital Audio Baby Monitor system produces a high-
pitched noise
•
The parent unit and the baby unit are too close to each other. Make
sure that the parent unit and baby unit are at least 1 metre away
from each other.
•
The speaker volume of the parent unit may be set too high.
Decrease the volume of the parent unit. Refer to section 3.3 for
volume level settings.
Battery pack in the parent unit is running low quickly
•
The volume level of the parent unit may be set too high, which
consumes power. Decrease the volume level of the parent unit.
Refer to section 3.2 for v olume level settings.