User's Guide

10
Getting started
2. Clip the battery cover back into place.
3. When charging the battery pack for the first time, place the handset on the
base to charge for at least 16 hours continuously.
4. When the handset is fully charged,
f will appear steadily on the display.
Plug the other end of the telephone line cord (make sure that one end is
already plugged into the base) into the telephone wall socket.
Connecting the handset and charger cradle
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process
for all the handsets and charger cradles.
1. Plug the AC power jack into the socket marked
on the underside of the
charger cradle and plug the power adaptor into the AC power outlet.
2. Remove the battery cover from the back of the handset by placing your
finger in the groove at the bottom of the handset and lifting the cover up
to release, then insert the 2 x AAA Ni-MH rechargeable batteries supplied.
Please note the ’+’ and ’-’ markings inside the battery compartment and
insert in the correct direction.
3. Clip the battery cover back into place.
4. When charging the battery pack for the first time, place the handset on the
charger cradle to charge for at least 16 hours continuously.
5. When the handset is fully charged,
f will appear steadily on the display.
The display will show the time and the date on the screen, to indicate that
it is registered to the base.
Battery low warning
If
l flashes on the display and there is a warning beep every 2 minutes during
a call, recharge the handset before using it again. When charging, f will scroll
on the display.