User's Guide

10
Connecting the handset and charger cradle
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process
for all the handsets and charger cradles.
1. Plug the AC power jack into the socket marked on the underside of the
charger cradle and plug the power adaptor into the AC power outlet.
2. Remove the battery cover from the back of the handset and insert the
2 x AAA Ni-MH rechargeable batteries supplied. Please note the ’+’ and
’-’ markings inside the battery compartment and insert in the correct
direction.
3. Slide the battery cover back into place.
4. When charging the battery pack for the first time, place the handset on the
charger cradle to charge for at least 16 hours continuously.
5. When the handset is fully charged, f will appear steadily on the display.
The display will show the time and the date on the screen, to indicate that
it is registered to the base.
Important
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA
Ni-MH 300mAh rechargeable batteries) supplied with your T6.
Battery low warning
If l flashes on the display and there is a warning beep every 2 minutes during
a call, recharge the handset before using it again.
When charging, f will scroll on the display.
Getting started