User manual
Table Of Contents
- 1: P1
- 2: Welcome!
- 3: Legal information
- 4: CE0168
- 5: Table of Contents
- 6: Important Notices
- 7: Getting Started
- 8: Phone Overview
- 9: Phone Overview
- 10: Phone Overview
- 11: Battery
- 12: Touch Screen
- 13: Touch Screen
- 14: Firmware Upgrade
- 15: Power on, off and Lock screen
- 16: Home Screen
- 17: Home Screen
- 18: Text input
- 19: Text input
- 20: How to Start;File Transfer
- 21: Safe Removal of Disk;Network Con
- 22: Phone 1
- 23: Phone 2
- 24: Phone 3
- 25: Phone 4
- 26: Message 1
- 27: Message 2
- 28: Browser1
- 29: Browser2
- 30: Browser3
- 31: Browser4
- 32: Browser5
- 33: Email 1
- 34: Email 2
- 35: Email 3
- 36: Email 4
- 37: music 1
- 38: music 2
- 39: video 1
- 40: video 2
- 41: Gallery 1
- 42: Gallery 2
- 43: Camera 1
- 44: App Center 1
- 45: App Center 2
- 46: Documents 1
- 47: Documents 2
- 48: Calendar 1
- 49: Calendar 2
- 50: note 1
- 51: Alarm Clock 1
- 52: Recorder 1
- 53: Calculator 1
- 54: Settings 1
- 55: Settings 2
- 56: Settings 3
- 57: Settings 4
- 58: Settings 5
- 59: Troubleshooting 1
- 60: care tips 1
- 61: care tips 2
- 62: care tips 3
Getting Started 11
Charging the battery
M462 is equipped with built-in rechargeable battery.
Use only the supplied power adapter and USB cable to charge the battery.
Do not remove the battery from the phone when charging the phone through
power adapter or automobile-used adapter.
How to charge the phone:•
If the battery is critical, the M462 will not boot. Connect it to a power adapter, and M462 will
display the charging animation. The Locked screen would display charging status. When the
battery is full, a full green battery would be shown on the Locked screen, and the animation
stops. Disconnect the power adapter from the power outlet, and then disconnect the M462.
Note:
1. If the battery is critical, the M462 will not boot.
Please try booting after 5 minutes of charging.
2. It normally takes 2-3 hours to fully charge the
phone.This can vary depending on if the phone
is on, if there are any calls while charging, etc.
3. For safety reasons, please use the standard USB
cable and power adapter.
1. Make sure the USB cable is placed correctly,
and then plug the cable into the M462’s micro USB
port which is in the bottom of the phone;
2. Plug the power adapter into a power outlet with
standard AC power applicable to the phone.
Battery
Note:Do not attempt to remove the back cover to take out or repair the battery.