Specifications

Picker Finger Position
If the cap frame option is not part of your system, you may refer to the following
procedure to center the picker fingers, should it become necessary.
If your EMT 10T has the cap frame option, you must give centering priority to the
cap frame driver. When the cap frame driver is centered properly, the picker fingers
will automatically come into proper center alignment. This is because the dovetail
clamp for the cap frame driver is fixed to the same bracket as the picker fingers.
1. Loosen the two picker/dovetail bracket screws on the cylinder arm shown in
Figure 4-17).
2a. Move the bracket left or right until the picker fingers are centered on the needle
shaft.
OR
2b. With both trimmers and cap frame options on the machine, move the bracket to
center the installed cap frame driver on the embroidery head arm.
3. Retighten the screws.
Front View
C
L
The Picker
should be
centered on
the Bobbin
Shaft.
Dovetail
clamp
Picker Height
Adjustment
Screws
Adjust Picker Home Position
here (locking set screw inside
swivel pin body)
Picker/dovetail bracket attachment screws (side to side picker
assembly positioning is made by loosening these 2 screws.)
Left Side View
Dovetail
clamp
Figure 4 - 17
4 - 24 Trimmer Adjustment Procedures
EMT 10T Technical Manual Melco Embroidery Systems