Specifications

Troubleshooting LEDs and Test Points
At the front of the EMT 10T is a metal cover plate over a variety of indicator LED
lights and a series of test points for checking certain voltages with a multimeter.
This area is provided for observing various machine conditions, especially while
troubleshooting problems that may occasionally occur. To access this area, remove
the screws holding the cover, flip the cover over so the lettering on the cover is
visible (as shown in Figure 1-2), and reinstall the cover in the same holes but above
the LED opening. The lettering on flip-side of the cover is a brief title for each of the
LED and test point locations. You may also refer to Figure 1-3 for this information.
lettering on
metal cover
indicator LED
lights and
test points
Figure 1 - 2
1 - 6 Troubleshooting LEDs and Test Points
EMT 10T Technical Manual Melco Embroidery Systems