Specifications

IMPORTANT: Do Not operate the embroidery peripheral with the
electronics cover removed. This cover provides the top of the EMI
shielding for reducing RF interference. Operating the equipment
without the shield (cover) can be a violation of FCC regulations.
Card Cage Components
Inside the card cage is found the Backplane PCB laying in the bottom with it’s
respective PCBs inserted upright into its connectors. The PCBs installed in the
EMT 10T Embroidery Peripheral are:
• The CPU PCB
• The Ethernet network PCB
• The Interface PCB
• The Low Voltage Driver PCB
• The XYZ Motor Driver Amplifiers
Refer to Figure 2-11 for identifying where each PCB is specifically located.
CPU PCB
The CPU PCB is the first PCB located to the front of the card cage as shown in
Figure 2-11. Refer to the following procedure for replacing the CPU PCB.
1. Turn OFF the power switch to the EMT 10T.
2. Remove the card cage cover and install a static grounding strap between the
working surface and the personnel performing this procedure.
3. Grasp the CPU at the top corners and gently rock it out of its connectors in the
backplane PCB. Remove the CPU.
4. Replace the CPU PCB by reversing the previous steps.
5. Remove the static grounding strap and replace the card cage cover.
6. Reinstall the right rear table top.
NOTE: If during this procedure, the CPU has been replaced with a different one,
you must "configure" the embroidery peripheral. Refer to the peripheral
operation manual and Section 1 of this manual for information regarding
the configuration process.
2 - 12 Electronics Section
EMT 10T Technical Manual Melco Embroidery Systems