Specifications

5. Remove the four cap head screws attaching the motor to the bracket standoffs.
6. Lift the motor away from the standoffs and allow the drive belt to slip off the
motor drive pulley.
7. Loosen the pulley set screws and remove the pulley from the motor shaft.
8. Place the pulley on the new motor shaft and slightly tighten one of the pulley set
screws.
9. Slide the motor mount bracket up and hold it in place while placing the motor in
position at the standoffs.
10. Be certain the bottom loop of the drive belt is below the motor drive pulley, then
reattach the motor to the standoffs with the four cap head screws removed
earlier.
11. Allow the motor and mounting bracket to slide down as the drive belt catches
the assembly in the center of the drive pulley.
12. Make certain the bottom loop of the drive belt is centered in the drive pulley. If
not, loosen the drive pulley set screw and adjust the pulley so it is directly below
the main Z drive pulley.
13. Tighten both Z drive pulley set screws.
Motor bracket
mounting/tensioning
nuts
Figure 3 - 1
3 - 2 Z Motor
EMT 10T Technical Manual Melco Embroidery Systems