Specifications

Jump Stitch Solenoid
Replacement
If a jump stitch solenoid must
be replaced, follow these
steps:
1. Color change the needle
case to needle #10 for
best access to the
solenoid area.
2. Remove the left color
change cover behind the
tensioner bracket
assembly by first
loosening the top two
screws then removing the
side two screws (see
Figure 3-12).
3. Remove the left arm front
cover to expose the jump
stitch solenoid mounting
bracket area (see Figure
3-13).
4. Use a pencil or other
suitable marking device
and mark the bracket
location in reference to
the front surface of the
arm casting at the
locations shown in Figure
3-13).
5. Cut any and all cable tie
wraps holding the jump
stitch harness, then
disconnect the jump
stitch harness in-line
connector from the
harness coming from the
side of the head.
top two
screws
side two
screws
left color
change cover
Figure 3 - 12
jump stitch
mounting
bracket area
(left arm front
cover removed)
note location
of solenoid
bracket in
reference to
the arm casting
arm casting
left arm front
cover mounting holes
Figure 3 - 13
3 - 14 Jump Stitch Solenoid
EMT 10T Technical Manual Melco Embroidery Systems