Specifications

CAUTION! The Color Change PCB is snapped into place on top of
the color change bracket. Be careful not to damage the photo
sensors or any other components when removing the PCB.
6. Remove the color change PCB by lightly prying up on the board near the 4 catch
pins that hold the PCB in place. The color change PCB should simply lift off of
the color change housing.
CAUTION! In the next step, press only on the board, DO NOT press
on board components. Use care not to damage the photo sensors
on the new PCB on the color change bracket on the needle case.
6. To reinstall the color change PCB, align the holes in the board over the catch pins
in the color change bracket and lightly press on the board to seat it in place. DO
NOT press on board components.
7. Reinstall the harness from the head and the ribbon cable from the tensioner PCB.
Also, reinstall all the covers removed to replace the color change PCB.
Color Change Motor Replacement
To remove the color change motor refer to the following steps:
1. Remove the color change area covers and tensioner covers as previously
described (see Figures 3-4 and 3-6).
2. Remove the color change PCB as described in just previous to this procedure.
4 catch pins
holding color
change PCB
color
change PCB
Figure 3 - 17
Color Change Motor Replacement 3 - 19
110291-01, Rev D 3. Embroidery Head Maintenance