Specifications

3. Remove the color change motor encoder cover (see Figure 3-18).
The color change harness connector at the color change motor encoder is captured
and is not removable unless the encoder is slightly disassembled.
CAUTION: Use extreme care in the next few steps not to damage
the color change motor encoder disc.
4. Loosen the color change motor encoder sensor ONLY ENOUGH TO REMOVE THE
HARNESS CONNECTION!
5. Carefully remove the harness connection from the encoder sensor.
6. Loosen and remove the 4 color change motor mounting screws
7. When the motor is loose, pull off the drive belt.
8. Loosen the pulley set screws and remove the motor drive pulley.
9. The motor is now loose and can be removed.
10. Replace the motor and reverse the preceding steps.
Again use CAUTION in attaching the color change motor encoder
harness connector to the encoder sensor.
11. Refer to the color change motor belt tension adjustment procedure to adjust the
belt.
4 motor
mounting screws
color change motor
2 pulley set
screws
motor
drive
pulley
drive belt
color
change
motor
encoder
cover
Figure 3 - 18
3 - 20 Color Change
EMT 10T Technical Manual Melco Embroidery Systems